|
Model & Ordering
 |
|
Specification
- Accuracy ( 23 + 5 oC ) : 0.3% RO
- Linearty & repeatability : 0.1% typical
- Temperature stability : Less 0.015% fs per degree C
- Configuration :
- Three wires connection / applicable for two wires
- Excitation - 5mAdc constant current source
- Changeable input module
- Linearized output vs input temperature
- Field rangeability :
- Selectable output mode for voltage or current mode
- Switchable of input ranges & output ranges
- Switchable AC power for 110V or 220V
- Selectable C / F calibration
- Effect of wire resistance :
- Automatically eliminated for 3 wire connection
- Offset recalibration required as for 2 wire connection
- Input break detection :
- Selectable Hi-set or Lo-set
- Hi-set over 110% of rated output
- Lo-set less 0.5% of rated output
- Power effect : Less 0.003% for per volt change
- Output drive capability : Maximum 10mA for voltage mode, maximum 10V for current mode
- Response time & ripple : Less 400ms typically, ripple less 0.15% rms of span
- Common mode rejection > 80db 50 / 60Hz
- Dielectric strength : 4KV AC between input / output / power / case
- Impulse & surge test : IEEE 587 / 1983 or IEC 255-3
- Storage condition : Temperature range -25 to +70oC, RH 20 to 95% non condensed
- Operating condition : Temperature range -20 to +65oC, RH 20 to 95% non condensed
- Power supply : +20% of rating, less 5VA
- Dimension : W*H*D : 12T (60.6mm) * 3U (128.5mm) * 238mm
|
|
