|
Model & Ordering
 |
|
Specification
- Accuracy ( 23 + 5 oC ) :0.1% RO
- Linearty & repeatability : 0.05% typical
- Temperature stability : Less 0.008% ro per degree C effective range
- Maximum input over : Voltage input
- 1.5 * rated / continuous
- 2 * rated / 10 seconds
- Dielectric strength : 4KV AC rms 1 minute between input / output / power / case IEC 688
- Impulse test : ANSI C37.90a / 1974, IEEE 587 / 1983, IEC 255-3 6KV (1.2 * 50 us)
- Surge test (ring wave) : IEEE 587 / 1983 (3KV~0.5us / 100KHz), IEC 255-3 (2.5KV~0.25ms / 1MHz)
- Configuration :
- Switchable of input ranges & output ranges
- +15% adjustability of fine span & zero
- Power effect : Less 0.003% for per volt change
- Input sensing :
- Input type both of plus unipolar or bipolar
- Waveform square pulse or sinusoidal signal or open collector
- Sensitivity 10mV to 5V adjustable 1V in factor preadjust
- Maximum over 100V continuous, 400V 1sec
- Excitation : +12Vdc, drive capability 20mA maximum
- Output drive capability : Less 10mA for voltage mode, 10V for current mode
- Response time & ripple : Less 400ms typically, ripple less 0.1% rms of span
- Common mode rejection > 100db, 50 / 60Hz
- Dielectric strength : 4KV rms AC between input / output / power / case
- Impulse & surge test : IEEE 587 / 1983 or IEC 255-3
- Storage condition : Temperature range -25 to +70oC, RH 20 to 95% non condensed
- Operating condition : Temperature range -20 to +65oC, RH 20 to 95% non condensed
- Power supply : +20% of rating < 3.5VA
- Dimension : W*H*D : 12T (60.6mm) * 3U (128.5mm) * 238mm
|
|
